April 30, 2019 at 4:49 pm #77355
I can run a test on each station though the app, and it shows that the stations are running, but they aren’t. I can also run a manual water cycle through the timer itself, says it is watering, but again no sprinkler heads popping up.
System was working fine, with no issues up until this past weekend. I don’t know what has changed. Timer shows that it is connected with 3 wifi bars, no issue connecting with apps either.
Hardware: wt25-0001Spread the love!May 1, 2019 at 12:03 pm #77378StephenKeymaster
It is possible that the timer is not sending out the voltage to the zones, but there could be an error somewhere downstream from your timer as well (water source, cut wires, etc.)
I would recommend testing the output of the timer with a volt meter (if you have one). If you cannot do that, then I would test the water source by turning the valves on manually.
You could contact our support group and they should be able to assist you with this. 1-800-488-6156Spread the love!May 4, 2019 at 9:16 am #77399
Thank you for the advise, however, I checked all stations with a multimeter, and all stations show that a signal is being sent to each station. I also checked ohms and all stations are 26.7 to 42.3.
I can run one station a day in auto or manual, doesn’t matter which station, and after that none of them will work in manual or auto for the rest of the day. I sometimes can’t even run one station on manual or auto for the day.
Nothing has changed from the time they were all working until now where nothing seems to work.
I have done a complete reset on the system to no avail. Rain delay has been turned off. Great wifi signal.
Any help would be greatly appreciated!Spread the love!May 4, 2019 at 11:21 am #77401
Also would like to know if I’m running the latest updates.
Thanks again!Spread the love!June 15, 2020 at 8:21 am #78760picasso1967Participant
is there an update this thread as I am having the same issue
MAC Address: 44:67:55:03:5d:60
Firmware Version: 0039
Hardware Version: WT25G2H-0001Spread the love!July 25, 2020 at 6:39 am #78887maurycupittParticipant
I have the same problem. Could an update be pushed if available please?
MAC Address: 44:67:55:41:0e:8f
Firmware Version: 0020
Hardware Version: WT24-0001
Wi-Fi Version: 0Spread the love!July 25, 2020 at 8:47 am #78888picasso1967Participant
We had a short or cut in the wire that was going up to the rain sensor in the back yard.
Cut the wires and twisted them together with a wire nut and tested the app and the heads start to pop up.
So sealed the ends with shrink wrap tube and its water proof and no more issues.
Hope is helps some peeps out thereSpread the love!
- You must be logged in to reply to this topic.