Home Community B-Hyve Indoor/Outdoor Timer Rain sensor contacts not working

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #76880
    mroe11517
    Participant

    I removed the jumper wire to install a rain sensor and the system did not see that the jumper was removed and produce a rain delay. I know there is a software switch that toggles on and off but am not sure what is supposed to be set at, on or off. In any case i tired it in both positions and still no rain delay, so i guess I might not put in the rain sensor switch, as it does not even delay when the jumper wire is removed. Any suggestions? If you want to look at my system, here is my mac address. 44:67:55:03:9E:C4. My firmware is #38

    Spread the love!
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Spread the love!