Home Community B-hyve Indoor Underground Timer Program won't run

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #4693
    emmastrong
    Participant

    Program won’t run, works fine on with manual settings. I do not have a rain sensor. Smart watering off. Please help!

    Spread the love!
    #4880
    Ryan
    Participant

    Hello emmastrong, if you don’t have a rain sensor installed then you will want to make sure that the sensor mode is turned off at your timer. Set your timer to auto, and then hold down your rain delay button. eventually either sensor off or sensor on will appear on your timers screen, indicating which mode your timer was just set to. I no rain sensor is installed than it must be set to off in order to function. Also if I could have you mac address I can check for any possible firmware updates too.

    Spread the love!
    #4899
    emmastrong
    Participant

    Ryan

    Thanks so much for your response. I have the bhyve indoor timer which has no screen per say. I held down the “b” in the center for a while and the only thing that came up was an “A” which I read is for All sprinklers and then when I let go it says system is off on my app. In other words there is no screen to tell me that the sensor is off. My mac address is 44.67.55.40.63.B8. If you can help that would be great.

    thanks so much

    Emma

    Spread the love!
    #4931
    Ryan
    Participant

    Hello emmastrong, I’m sorry I didn’t realize you had our indoor model. does your timer still have the jumper cable inserted into the sensor terminals on your timer?

    Spread the love!
    #4940
    emmastrong
    Participant

    No there were not jumper cables in the sensor terminals.

    Spread the love!
    #4965
    Ryan
    Participant

    emmastrong, ok you will want a short piece of wire then to insert between the two sensor terminals then. If it’s still not allowing scheduled watering’s to occur after that please let us know.

    Spread the love!
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.
Spread the love!