Home Community B-hyve Indoor Underground Timer New Install Issues – Pump Fault

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #4431
    njacques
    Participant

    I am trying to complete an initial install of the timer. At first it wasn’t connecting to the internet, but I read these forums and changed my router so it was able to connect to the 2.4G network. Now it’s connected but when I try to test a zone, it gives me a pump fault error and the light changes to red. I’m assuming this is a firmware issue as I do not have a pump – can you check on that for me?

    MAC: 44:67:55:40:22:50
    Firmware: DEBUG-0013
    Hardware: WT24-0001

    Spread the love!
    #4518
    Ryan
    Participant

    Hello njacques, I can update your firmware, but that will most likely not fix your issue. It s most likely because your timer is not compatible with your pump start relay. Is it showing a pump fault for all of your stations or just some of them?

    Spread the love!
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.
Spread the love!