Home Community B-Hyve APP Forum Did not run it’s full programmed length and 1hr delays between zones.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #2290
    Rolo
    Participant

    Hello,
    I purchased and installed the b hyve yesterday. Install, set up and tests all ran smoothly. I created a custom schedule to run nightly for one hour. When I checked the watering history this morning each zone reads that they only ran for one minute. I’ve changed each zones run time now to 55 minutes but I’m noting another issue; each zone delays it run time by an hour. For example if zone 1 runs at 12:00am 55 minutes, zone 2 will not start until 1:55am.
    How can I ensure the zones run the length of time I set it for?
    How can the zones run back to back with now delays?
    MAC 44:67:55:02:99BA

    Spread the love!
    #2390
    KerriBU98
    Participant

    We are having the same problem. We only have one program setup with one start time. Each zone is set to run for 20 minutes. Instead of zone 2 starting when zone 1 is finished, it waits for 20 minutes, then zone 2 starts. The time keeps stacking or delaying like this.

    Spread the love!
    #2391
    Rolo
    Participant

    I’ve had this post active for a few days now, no response from bhyve. I also now encountered three nights in a row rain delays despite no rain. I called bhyve and after waiting on hold for 30 mins the only thing I was told was that my firmware was out of date and they pushed through an update. I’m hoping for a miracle tonight when my program is due to run. We shall see otherwise I will be calling again.

    Spread the love!
    #2431
    Stephen
    Keymaster

    @rolo it looks like your timer has the rain sensor terminal active, hold down the Rain Delay button for about 5 seconds and it will show “SENS OFF”. this stops the rain sensor terminals from causing your timer to turn off after 1 second of running. As far as the issue with the timer waiting for an hour before starting the next station, I’ve never seen that issue and I’m not sure what would cause it. It may be an issue with the rain sensor terminal. Turn that off and let me know if you still see the same issue.


    @kerribu98
    what is the MAC ID of your timer? You may be having the same issue as @rolo. Try what I’ve suggested above and let me know if that resolves your issue.

    Spread the love!
    #2466
    KerriBU98
    Participant

    Turned off rain sensor terminal but that didn’t resolve the issue. MAC ID 44:67:55:02:CC:55

    Spread the love!
    #2498
    Stephen
    Keymaster

    @Kerribu98, I show your timer is not running the full duration now, when you held down that button, did it say SENS ON or SENS OFF?

    Spread the love!
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.
Spread the love!